Thursday, January 28, 2010

LMTools Ports Unblocked

Found this good info on the Autodesk discussion group....

"2080 and 27000-27009 needs to be unblocked.
Jimmy Bergmark"

"The technical reason behind this is that it's structured as two independent executables.The lmgrd by default takes one of the 2700X ports which lmtools and the application would communicate with.Then the traffic is relayed to the adskflex daemon which runs on 2080. However often it's not specified to a fixed port (Autodesk is an exception here) and therefore you can see this behavior of multiple ports in action and randomized port numbers.
Best regards,Henrik Goldman"